±â¼úÀÚ·á  
CNC
WEDM
¿¬±¸ ¹ßÇ¥ ³í¹®ÀÚ·á

 
 
HOME > ±â¼úÀÚ·á> °ü·Ã³í¹®
   
 
   
  [IJPEM (Çѱ¹/SCIE)] Effect of Machining Area on Material Removal Rate in Strip EDM
  ±Û¾´ÀÌ : °ü¸®ÀÚ     Á¶È¸ : 4180    
  Æ®·¢¹é ÁÖ¼Ò : http://sharp-eng.com/web/bbs/tb.php/group_02_b_03/194
ÇмúÁö¸í: Journal of Precision Engineering and Manufacturing
¹ßÇà±¹°¡: Çѱ¹
¹ßÇ¥ÀÏÀÚ: 2015³â 11¿ù
SCI¿©ºÎ  :  SCIE
¿ø¹®Link: http://link.springer.com/article/10.1007/s12541-015-0313-9

Á¦¸ñ:Effect of machining area on material removal rate in strip EDM
ÀúÀÚ: ¼Û±â¿µ(»þÇÁÁ¤¹Ð) ÁÖÁ¾³²(¼­¿ï´ëÇб³)
³»¿ë: ½ºÆ®¸³ ¹æÀü°¡°ø¿¡¼­ÀÇ ¸éÀûÈ¿°ú¸¦ ¿¬±¸ÇÏ°í °¡°ø¼Óµµ´ëºñ Àü±Ø¼Ò¸ðÀ²À» Á¦½ÃÇÔ.

ÃÊ·ÏAbstract:
Strip EDM is similar to wire EDM, except that the electrode is a roll of brass strip. In this study, investigated is the effect of machining area on material removal rate (MRR) in strip EDM, The MRR was measured according to different machining areas and different electrical discharge conditions. For a given discharge condition, optimal machining area for maximum MRR was identified. The optimal machining area was larger under higher discharge energy condition. It is shown that strip EDM is much more efficient than wire EDM because material removal rate is much higher and the electrode consumption is much less.